Lab

If circuit is built without resistor and fingertip bridges the gap the lamp will light. Water will also turn the circuit on, so it could be used to monitor any place that should stay dry. The lamp could be replaced by a sonalert for an audible alarm.

An interactive circuit built in the DCACLab online simulator by Sam Watson. Open it to run the simulation and measure it.

Preview of If circuit is built without resistor and fingertip bridges the gap the lamp will light. Water will also turn the circuit on, so it could be used to monitor any place that should stay dry. The lamp could be replaced by a sonalert for an audible alarm.
Open in the lab Embed Run the circuit right here. To edit it in the full lab, sign in; free accounts have a time limit there.

Teaching with circuits?

Create a classroom, give your students a circuit to build, and review what they submit. Try it free with one classroom and up to 5 students.

Try the free classroom demo

About

By Sam Watson
Saved May 16, 2014 · updated August 14, 2014
11,292 views
Page: dcaclab.com/circuits/9841-touch-activated-switch

Embed this circuit

<iframe src="https://dcaclab.com/experiments/9841-touch-activated-switch/iframe" width="560" height="410" frameborder="0"></iframe>

Cite: Watson, S. (2014). If circuit is built without resistor and fingertip bridges the gap the lamp will light. Water will also turn the circuit on, so it could be used to monitor any place that should stay dry. The lamp could be replaced by a sonalert for an audible alarm. DCACLab. https://dcaclab.com/circuits/9841-touch-activated-switch