RC Low-Pass Filter: Frequency Response Lab
A 1.6 kΩ resistor and a 1 µF capacitor make an RC low-pass filter with a 99.5 Hz cutoff. Run an AC sweep from 1 Hz to 10 kHz and read gain and phase.
Use this circuit in class: RC low-pass filter lab: cutoff frequency and AC sweep
Want to build your own circuit? Start a new circuit in the circuit simulator
Teaching with circuits?
Create a classroom, give your students a circuit to build, and review what they submit. Try it free with one classroom and up to 5 students.
Try the free classroom demoHow it works
A resistor in series and a capacitor to ground pass slow signals and block fast ones. The cutoff frequency is fc = 1/(2πRC): with 1.6 kΩ and 1 µF it is 99.5 Hz, where the output is 0.707 of the input and lags it by 45°.
The source is a 10 V peak, 100 Hz sine wave. In the full lab, the NGSpice AC Sweep chart plots the output (N2) in volts and its phase in degrees from 1 Hz to 10 kHz, and the Time Domain chart shows the smaller, delayed output wave.
What's inside
- 1× Power Source
- 1× Resistor (1.6 kΩ)
- 1× Capacitor